cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
515
Views
0
Helpful
3
Replies

Cisco Prime 3.8 remove some Switch/Router interfaces from monitoring

ryosaeba86
Beginner
Beginner

Hi All,

 

I just installed Cisco Prime version 3.8 for a campus network. What I would now like to do is remove some ports (those connected to office PCs and / or telephones) from alarm monitoring. Now I get a lot of "link down" alerts that I don't care to monitor. Following other discussions I created a "Port Group" with only the UpLink ports later in Monitor-Monitor Policies I added a policies with the new group disabling the main Policies (Link & Trunk Ports).
But I still get "link down" alerts from other interfaces as well.

Do you have any suggestions?

Thanks

3 Replies 3

marce1000
VIP Mentor VIP Mentor
VIP Mentor

 

 - You may be able to change the severity level (or category) of these alerts.

 M. 


@marce1000 wrote:

 

 - You may be able to change the severity level (or category) of these alerts.

 M. 


Ok, sorry may you tell me how to do this?

Thanks.

 

 

                                                       - Have a look at this document :

          https://www.cisco.com/c/en/us/td/docs/net_mgmt/prime/infrastructure/3-2/user/guide/bk_CiscoPrimeInfrastructure_3_2_0_UserGuide/bk_CiscoPrimeInfrastructure_3_2_0_UserGuide_chapter_01001.html

 M.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers