cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
35
Views
0
Helpful
0
Replies
Highlighted
Beginner

Cisco Prime 4.2- Still getting fault events for removed cards

We removed an end of life card from a switch chassis, running the module clear-config to remove the old configuration from the chassis as well. Cisco Prime 4.2 continues to generate faults for a missing card, even though we ran a new inventory and sync archive. Is there a way to prevent new fault management events for this card? Yes, I can remove the device and add it back in to Prime, but that destroys all of our historical configuration information & is not a desirable option.

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards