cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
369
Views
0
Helpful
1
Replies
Highlighted
Beginner

Cisco Prime Infrastructure 2.2 - can we load PI2.2 on UCS-E140S-M2/K9 -

I am busy with an iWAN design and part of the solution is to have Cisco Prime deployed as a management tool.

The customer does not have VM and do not want an appliance.

The design caters for the new ISR4400 series routers.

We can add a UCS-E single wide server to the Core Router - UCS-E140S-M2/K9- can I load PI2.2?

The site will have 45 routers, 10 AP's - so will go with 50 lifecycle and assurance licences

 

1 REPLY 1
Highlighted
Cisco Employee

I'm afraid this is supported officially. There are only two options :

> Installing as a virtual appliance - on an ESXi server.

> Using Cisco Physical Appliance

Installing directly on another hardware, be it UCS or other physical boxes is not supported. I am not sure if anyone would have tried to install and if there is a procedure to do so.

I can you want to try to burn the image as iso on DVD and install on your UCS box, it may have support issues from TAC whenever you'll reach out.

-Thanks

Vinod 

**Encourage Contributors. RATE Them**

-Thanks Vinod **Rating Encourages contributors, and its really free. **
Content for Community-Ad