Cisco Prime Infrastructure EVAL HELP!

[Chris Alvarado]

Just installed the evaluation copy of Cisco Prime Infrastructure 3.2. I went through the setup prompts and I can ping the server from my network and from a network stand point it seems good. However I can not web into the system to actually trial this. The troubleshooting guide says to run command 'ncs status' to check the status of the server. However I get the following error.

sh: /opt/CSCOlumos/bin/wcsadmin.sh: No such file or directory 

Please advise on how I can get this running. 

[marce1000]

 - Can only assume that the install got corrupted for some reason; make sure that you are using a supported/compatible  platform (hypervisor/version) (e.g.). And take into account the needed systen resources required too.

M.

[Bill Longman]

That's what I would say, too. Are you sure you installed with enough disk space?

[Chris Alvarado]

I meet all the hardware specs as defined by the recommended Express version. Should I do a reinstall?

[iportuga]

Yes, please do a reinstall.