cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
309
Views
0
Helpful
4
Replies
Beginner

Cisco Prime Infrastructure EVAL HELP!

Just installed the evaluation copy of Cisco Prime Infrastructure 3.2. I went through the setup prompts and I can ping the server from my network and from a network stand point it seems good. However I can not web into the system to actually trial this. The troubleshooting guide says to run command 'ncs status' to check the status of the server. However I get the following error.

 

sh: /opt/CSCOlumos/bin/wcsadmin.sh: No such file or directory cisco_prime_sreen_shot.jpg

 

 

Please advise on how I can get this running. 

 

 

 

4 REPLIES 4
Rising star

Re: Cisco Prime Infrastructure EVAL HELP!

 

 - Can only assume that the install got corrupted for some reason; make sure that you are using a supported/compatible  platform (hypervisor/version) (e.g.). And take into account the needed systen resources required too.

M.

Highlighted
Cisco Employee

Re: Cisco Prime Infrastructure EVAL HELP!

That's what I would say, too. Are you sure you installed with enough disk space?

Beginner

Re: Cisco Prime Infrastructure EVAL HELP!

I meet all the hardware specs as defined by the recommended Express version. Should I do a reinstall?

Cisco Employee

Re: Cisco Prime Infrastructure EVAL HELP!

Yes, please do a reinstall.
CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards