Cisco Prime Infrastructure HA - HA Mode Change

[George Weatherall]

I'm in the process of configuring a new Cisco Prime Infrastructure HA pair, but the server which was to be the secondary was accidentally configured as stand-alone. Is it possible to change this to the secondary in an HA pair after it has already been configured? I have been unable to find any commands via CLI or GUI that would allow me to configure this device as a secondary HA server. I'd prefer not to have to rebuild the whole server, but it's starting to look like I may have to.

[AFROJ AHMAD]

Hello,

If you don't want to start again then you need to contact TAC , they can engage BU . they know how to make it in HA setup even after  the installation of secondary server as standalone.

**there is no direct way to do this , some properties files and config need to be changed

Thanks-

Afroz

*****Ratings Encourages Contributors ***