Cisco Prime NCS Install

[Ben Skinner]

Hi,

I am trying to play around with NCS.

I have ESXi box (4.1 and 5) and have tried using both ver 1.0 and 1.1 of the appliance.

The error i get on boot up is

Failure during Network Control System startup. Check launchout.log for details

How can i check that logfie?

[mkilic]

I have same error.

Failure during Network Control System startup.  Check launchout.log for details.

[rafael.libanio.sp]

Dear,

follows this procedure to be performed. I tested it and it worked.

=================================================================

1.> Please try these commands then try to start

the ncs:

ncs stop ( 3 times)

reload.

ncs status ( email me the o/p)

2.> If the #1 does not helps  please run 

ncs cleanup

3> Note: If the above does not help, and only if *** this is new install ***, it might

be ok to re-init the DB ( use your own judgement )

Note: NCS DB you will loose previous data when you re-init. but if this DB corrupt issue

may help.

the ncs:

ncs stop

ncs db reinitdb

ncs start

=================================================================

Hugs.

[Craig Le-Butt]

Hi

Did you problem heve get sorted?  I'm having the same issue, looked at launchlog, which says check startup.log which seems to be da."startup.log"

I've found some errors, but can't find anywhere to check these against.

anyone have any ideas, don't realy want to reonotdb.

cheers

[relder]

Just happened to me.  I am running version 1.3.0.20.

I already did a NCS CLEANUP, and it finished sucesfully, but unable to start it.  It looks like I have enough space..

I have 30,293,413,888 byes available.  So i don't think it is a disk space issue.  The device was working good till today.

Thanks!

Edit - I did reboot it as well.  Nothing.