Cisco Prime v2.2 and Catalyst 6509 SNMP "time out"

[jlinkowsky]

Good afternoon,

I have PI v2.2 up and running and my v2.1 data restored.  Went very smoothly.  I have all my WLC's added and re-sync'd, but when I'm trying to re-sync my 6509s, I'm getting an SNMP Connectivity Failed.

It states that the possible cause could be "SNMP request timed out.  Verify device credentials and SNMP response speed from device."

I have verified the SNMP credentials, and they are correct.

Any ideas/suggestions?

Thanks,

John L.

[emartens]

Hi

I've the same issue after upgrading from v1.3 to v2.2

All other devices seems to be ok. But all 650x with IOS 15.1(1)SY1  & 15.1(2)SY1

[matti.a.heikkinen]

Hi!

Same problem here! We upgraded to v2.2 and after that we have had difficulties with 6509 with IOS 12.2(33)SXJ7. Catalyst 6009 and 6506 are both ok. Only this one says " "SNMP request timed out.  Verify device credentials and SNMP response speed from device."

We have checked SNMP credentials and increased time-out value to 20 with no effect.

Is this again a product which has not tested with older switches at all...?

br, Matti

[matti.a.heikkinen]

Hi! Our problem was solved when we upgrated to version 3.0.

br,

Matti

[AFROJ AHMAD]

Hi John,

try editing the

Reachability Retries to 3

 Reachability Timeout     to 15

Go to "Administration > System Settings > SNMP Settings"

check the issue again.

Thanks-

Afroz

***Ratings Encourages Contributors ****

[You-Heng EA]

We have the same issue:

Cisco Prime Infrastructure: 2.2.2

cisco WS-C6509-E  : Version 12.2(17r)SX7,