11-21-2014 07:29 AM
Hi, is it possible the get the MAC address table on SG300 switches with SNMP?
I tried with OID 1.3.6.1.2.1.17.4.3.1.1
But no result
Here is the SNMP configuration
snmp-server server
snmp-server community Test rw view DefaultSuper
11-21-2014 11:26 AM
Even the latest MIBs for SG 300 here doesn't shows BRIDGE-MIB. Try to poll the entire Bridge MIB to see if that brings result. Poll device for 1.3.6.1.2.1.17.
Also, if there are positive results/output, poll as per community string indexing.
Follow this document to get the details on mac address table.
From the config, it seems to be incorrect. You have not configured any View but attached you community to view DefaultSuper. This is not required, try configuring device just for snmp-server community test ro for the time being for testing.
For more details on CLI commands for SG 300 check document here.
-Thanks
Vinod
11-21-2014 01:24 PM
Thank for your answer
Polling the entire Bridge MIB brings result
I've tried the idexing but when I'm using test@10 for VLAN10 I get this log in the switch: %SNMP-W-SNMPAUTHFAIL: Access attempted by unauthorized NMS
I've also tried to remove the view but still have no result
Any idea?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide