Cisco SG300 Mac address table with SNMP

[emergismsh]

Hi, is it possible the get the MAC address table on SG300 switches with SNMP?

I tried with OID 1.3.6.1.2.1.17.4.3.1.1

But no result

Here is the SNMP configuration

snmp-server server
snmp-server community Test rw view DefaultSuper

[Vinod Arya]

Even the latest MIBs for SG 300 here doesn't shows BRIDGE-MIB. Try to poll the entire Bridge MIB to see if that brings result. Poll device for 1.3.6.1.2.1.17.

Also, if there are positive results/output, poll as per community string indexing.

Follow this document to get the details on mac address table.

From the config, it seems to be incorrect. You have not configured any View but attached you community to view DefaultSuper. This is not required, try configuring device just for snmp-server community test ro for the time being for testing.

For more details on CLI commands for SG 300 check document here.

-Thanks

Vinod

[emergismsh]

Thank for your answer

Polling the entire Bridge MIB brings result

I've tried the idexing but when I'm using test@10 for VLAN10 I get this log in the switch: %SNMP-W-SNMPAUTHFAIL: Access attempted by unauthorized NMS

I've also tried to remove the view but still have no result

Any idea?