cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

239
Views
0
Helpful
12
Replies
Beginner

Cisco SG350X Switch - pruned CLI?

Hi there,

 

i'm not able to ocnfigure "enable secret" or even "service password-encryption" commands on the cli of my SG350X switch. Is the CLI really so much cut-off or do i try to use obsolete commands?

12 REPLIES 12
Highlighted
Rising star

Re: Cisco SG350X Switch - pruned CLI?

 

 - Make sure that you  are not logged on with a user who has been deprived of sufficient rights to execute these commands. And so which errors are you getting when trying this ?

 M.

Beginner

Re: Cisco SG350X Switch - pruned CLI?

No, this is the default user with full rights...i assume. The switch is new. I've updated ios to 2.5.X so the firmware is also up to date. It just seems that these commands are cut-off. 

Rising star

Re: Cisco SG350X Switch - pruned CLI?

 

 - Verify current user privilege anyway with show privilege ; besides that what options are listed when enable ? is inputted ?

 M.

Beginner

Re: Cisco SG350X Switch - pruned CLI?

Hi,

besides...thank you for your help.

So here are the results:

 

SWITCH1#show privilege
Current privilege level is 15

 

SWITCH1(config)#enable ?
password Assign the privileged level password.

 

 

Rising star

Re: Cisco SG350X Switch - pruned CLI?

 

 - Looks promising please post the fulll enable-command-tried and the resulting error too.

    M.

Beginner

Re: Cisco SG350X Switch - pruned CLI?

Hi, in both cases i get "% Unrecognized command":

 

SWITCH1(config)#enable secret 0 pass
% Unrecognized command
SWITCH1(config)#service password-encryption
% Unrecognized command
SWITCH1(config)#exit
SWITCH1#enable secret 0 pass
% Unrecognized command
SWITCH1#service password-encryption
% Unrecognized command

Rising star

Re: Cisco SG350X Switch - pruned CLI?

 

 - Which options are available when you give this command : enable secret ?

    M.

Beginner

Re: Cisco SG350X Switch - pruned CLI?

If i put a "?" (question mark) after "enable secret", i get this:

 

SWITCH1#enable secret
% Unrecognized command

Rising star

Re: Cisco SG350X Switch - pruned CLI?

 

 - And which command options are listed when you enter the enable ? command.

   M.

Beginner

Re: Cisco SG350X Switch - pruned CLI?

Hi Marce,

 

we had that already . See aboth postings (-;

 

SWITCH1(config)#enable ?
password Assign the privileged level password.

 

There is just no "enable secret".

Rising star

Re: Cisco SG350X Switch - pruned CLI?

 

 - I can only assume then that the SG350X platform does not offer enable secret ; you can find the differences  with enable password explained from the link below :

      http://www.differencebetween.net/technology/difference-between-enable-and-enable-secret-password/

 M.

Beginner

Re: Cisco SG350X Switch - pruned CLI?

Yeah, that's what i was aiming for. Just wanted a confirmation for this. There are other things that i saw in this time i've worked with this switch like a missing vlan.dat or missing "mls" command. Thank you nethertheless.

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards