CiscoWorks 3.1 and Nexus 5K/7K

[tayebmesbah]

Hi,

I can't add any Nexus devices that we just installed on CiscoWorks 3.1 ? Is there any patch that I need to install to get this working and where are located.

Thanks

[Marvin Rhoads]

CiscoWorks 3.1 is over 3 years old (End-of-Sales December 2009) and is now end of support. It had very limited support for Nexus devices - most of the current Nexus gear was released after development stopped on CiscoWorks 3.1.

The Supported Devices Table for 3.1 shows exactly what's possible.

The current Cisco Prime LMS 4.2 has pretty good support for Nexus switches.