Addtionally, I require LMS to verify that the port is indeed an access port with 802.1x already applied to it before adjusting the configurations. I have tried pushing this compliance check out with a prerequisite of having "switchport mode access" applied to it, and then having the next command set state:
Submode: interface [#Ethernet*/*/*#]
- dot1x max-req 1
- dot1x max-reauth-req 1
+ no dot1x max-req 1
+ no dot1x max-reauth-req 1
This was a simple test on a single device to see if I could remove the limits on authentication and requests entered. The job states successful and there are no devices that are non-compliant, however no changes to the device configurations have been made. I seek assistance in command syntax or if there is another way to push this out, as I have about 1k network devices to go through and make these changes.
PRTG system in place running other sensors on the same host, which are working. Ive added syslog receiver sensor and receiving PRTG data from switch that increases drops, errors and warning stats that disappear after a few minutes. Within mess...
Hi, here is an example how to configure IP-NAT, GRE, IPSEC. I've seen plenty of questions and this might be a good solution! (Mostly the use of commands that might remind u) IP NAT======================================================================...
Hi everyone.I have a problem in my Network.So i have 3 routers and a firewall in my topology. I have configured OSPF and all routers works expect R3 (see in the image below)When I watch my neignbor in R3 it says :192.168.7.7 1 INIT/DROTHER 00:00:37 10.0.2...
Host Onboarding is the term used when connecting an endpoint (hosts , IOT , Other devices) to the fabric , and can be accomplished in a couple of ways.One option is the "static" approach as oppose to the dynamic and secure approach using&nbs...