cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
502
Views
0
Helpful
1
Replies
raza555
Beginner

CiscoWorks configuration changes reports required

HI,

I am using CiscoWorks LMS 3.2.1. Please advise that how I can generate a report that shows that configurations changes made by the someone similar to below “sh archive log config all”

I can generate a report from RME->Report->Report Generator->Syslog-> then tried all types of option for report generation. But I get report just saying that Devices interface has ben up/down. Primary vlan changes; but these all are not usefull for me..

I need a report that who has login to router/switch via telnet/ssh/snmp, make any changes, or been to conf t similar to as below. Please advise if its possible to create these type of reports.

Switch-1#sh archive log config all

idx   sess           user@line     Logged command

   1     1       user1@vty0     | logging enable

   2     1       user1@vty0     | logging size 500

   3     1       user1@vty0     |  hidekeys

   4     1       user1@vty0     | notify syslog

   5     2       user1@vty0     |interface GigabitEthernet1/0/2

   6     2       user1@vty0     | description testing-2

   7     3       user1@vty0     |interface GigabitEthernet1/0/3

   8     3       user1@vty0     | description testing3

1 REPLY 1
AFROJ AHMAD
Cisco Employee

Hi Rizwan,

check the below threads. It is possible via Chnage Audit .

https://supportforums.cisco.com/thread/2242841

https://supportforums.cisco.com/thread/2241836

also look at the below link:

http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_lan_management_solution/4.1/user/guide/admin/caudit_swim.html

Hope this will help

Thanks-

Afroz

[Do rate the useful post]

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****