you can select the option to auto allocate a certain group which this device is listed under.
if this group contain more than the device you need then you can go to
RME > Device > Device managment > Normal devices > select and suspend the un-needed devices.
in this case you will have your device in RME and the others are suspended.
hope this helps
hi fadi twal,
i added a new device on common services.And i have clicked Enable Auto Mode (RME > Admin > Device Mgmt > Device Man. Settings)
but i can't see the new device in RME. i am searching the device in RME > Devices > Device Management | RME Devices)
shouldn't i see the new device in RME automatically?
rme update itself as soon as add device to common service
so it seems that there was a process stuck or the properties file not updated,
to make sure that the issue is gone try to delete the device from CS and check in RME,
then try to add it again and check RME (make sure that the device is added to the DCR correctly)