11-17-2010 12:02 PM
Is there any reason why Ciscoworks would be able to obtain circuit utilization on some router interfaces and not all?
I have a serial interface that occasionally experience high utilization and when I go to DFM under DDV>click the interface>it the current utlilization % is -
This is bad.
11-25-2010 08:51 PM
This is an dial-on-demand interface. DFM doesn't do utilization tracking for those interfaces. If you want to change this, go to DFM > Configuration > Polling and Thresholds > Managing Thresholds. Edit the thresholds for Dial-On-Demand interfaces, and enable the generic interface settings. Then apply your changes and you should be able to get the utilization.
11-26-2010 05:31 AM
Worked like a charm.....thanks for you response.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: