cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
812
Views
0
Helpful
2
Replies

Ciscoworks DFM interface polling

dionjiles
Level 1
Level 1

Is there any reason why Ciscoworks would be able to obtain circuit utilization on some router interfaces and not all?

I have a serial interface that occasionally experience high utilization and when I go to DFM under DDV>click the interface>it the current utlilization % is -

This is bad.

2 Replies 2

Joe Clarke
Cisco Employee
Cisco Employee

This is an dial-on-demand interface.  DFM doesn't do utilization tracking for those interfaces.  If you want to change this, go to DFM > Configuration > Polling and Thresholds > Managing Thresholds.  Edit the thresholds for Dial-On-Demand interfaces, and enable the generic interface settings.  Then apply your changes and you should be able to get the utilization.