cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
814
Views
0
Helpful
2
Replies

Ciscoworks DFM interface polling

dionjiles
Level 1
Level 1

Is there any reason why Ciscoworks would be able to obtain circuit utilization on some router interfaces and not all?

I have a serial interface that occasionally experience high utilization and when I go to DFM under DDV>click the interface>it the current utlilization % is -

This is bad.

2 Replies 2

Joe Clarke
Cisco Employee
Cisco Employee

This is an dial-on-demand interface.  DFM doesn't do utilization tracking for those interfaces.  If you want to change this, go to DFM > Configuration > Polling and Thresholds > Managing Thresholds.  Edit the thresholds for Dial-On-Demand interfaces, and enable the generic interface settings.  Then apply your changes and you should be able to get the utilization.

Worked like a charm.....thanks for you response.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: