cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
502
Views
0
Helpful
3
Replies

CNA 5.8.9.1 not allowing access to 2960X running 15.0(2)EX4 even though credentials are correct

eharbensc
Beginner
Beginner

Hi All,

Are there any known issues with CNA 5.8.9.1 compatibility with a C2960X switch running 15.0(2)EX4?

When I attempt to log in to the switch, I am informed the credentials are invalid although the same credentials work when using the CLI.

Best Regards,

-Evan

1 Accepted Solution

Accepted Solutions

Marvin Rhoads
VIP Community Legend VIP Community Legend
VIP Community Legend

Have you specified the ip http authentication mode on the switches? CNA uses the http server on the target device.

Test your credentials against the device web interface to verify.

View solution in original post

3 Replies 3

Marvin Rhoads
VIP Community Legend VIP Community Legend
VIP Community Legend

Have you specified the ip http authentication mode on the switches? CNA uses the http server on the target device.

Test your credentials against the device web interface to verify.

This is what was missing on the switch. Thank you very much Marvin :)

You're welcome - glad it helped. Thank for the rating.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers