cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3400
Views
0
Helpful
2
Replies

CNA 5.8 - unable to add members to a community

Anthony MOULIN
Beginner
Beginner

I try to add a  Catalyst 2960 to Cisco Network Assistant, I get the prompt for password but I get a "Authentication failed". I use the same login / password for telnet that works fine. Http admin page is reachable but I cannot login with the "admin" account...

Show run says :

ip http server

ip http secure-server

Any tips ?

Config file attached...

Thanks

1 Accepted Solution

Accepted Solutions

Marvin Rhoads
VIP Community Legend VIP Community Legend
VIP Community Legend

Try adding "ip http authentication local"

View solution in original post

2 Replies 2

Marvin Rhoads
VIP Community Legend VIP Community Legend
VIP Community Legend

Try adding "ip http authentication local"

It works !!!

Thank you for your help Marvin !

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: