I've got an 1811 that I managed through a combination of CLI, CCP, and SDM, as the mood strikes me. I recently tried used Cisco Network Assistant (v5.5) to configure a Catalyst switch and was very impressed with its capabilities and responsiveness. I tried to use it on the 1811, but ran into some problems.
CNA can discover the device, but the only menu that shows up under "Configure" is the "Device Properties" menu. All that's under there is the hostname system time, http port, and user accounts. I expected to find menu items that allowed me to configure the Ports, routing, vpn, and other features of the 1811.
The CNA release notes claim support for the 1811, but, being new to CNA, I don't know if that necessarily implies full support for configuration.
So ... any thoughts? Is this as good as it gets as far as using CNA to manage the 1811? Or is something screwed up on my side?
Show CommandPurposeCiscoICX-RuckusShow Spanning tree infoShow spanning-treeshow 802-1wVerify Port-Channel / Link aggregation infosh lag briefsh etherchannel summaryShow CDC/LDP neighbor infoshow cdp neighbors detailsh lldp neighbors de sh mac a...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.
Introduction to SD-Access Multicast
The document describes the Cisco DNAC UI workflow introduced as part of the Cisco DNA Center1.3.3 release. The document covers the components of Multicast forwarding on SD-Access fabric and the configuration pushed to...