cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
855
Views
0
Helpful
2
Replies

Compliance Check/Deploy DCMA0058 error

lanwancig1
Beginner
Beginner

Hi

Using LMS 3.2 RME 4.3.0. I'm trying to deploy baseline config after compliance check. When I select compliance check job and click deploy i got this error:

"DCMA0058: Could not deploy selected Job.
No compliance report available."

But the report in baseline jobs window i available.

Any ideas what should i check ??

1 Accepted Solution

Accepted Solutions

Nael Mohammad
Contributor
Contributor

Please run a device update from Common Services --> Software Center --> Device Update --> Select RME under products and check for updates from Cisco.com and install all the device packages.

Duplicate the problem again after update and post the error if it appears again.

View solution in original post

2 Replies 2

Nael Mohammad
Contributor
Contributor

Please run a device update from Common Services --> Software Center --> Device Update --> Select RME under products and check for updates from Cisco.com and install all the device packages.

Duplicate the problem again after update and post the error if it appears again.

Thanks a lot. Seams to work for me.