cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1130
Views
0
Helpful
5
Replies

Configure 2811 via snmp

Jackdawe67
Beginner
Beginner

Is is possible to configure a 2811 router with

HWIC9ESW module via snmp?

I have snmp enabled and set-up on FE0/0.

Thanks in advance

GD

5 Replies 5

yjdabear
Collaborator
Collaborator

You could place a full running config for the 2811 on a TFTP server, then use SNMP to copy it to the 2811 as described in the link:

http://www.cisco.com/en/US/tech/tk648/tk362/technologies_tech_note09186a008009463e.shtml

Jackdawe67
Beginner
Beginner

Thanks yjdabear for the reply.

I read that one and the copy config article at:

http://www.cisco.com/en/US/tech/tk648/tk362/technologies_configuration_example09186a0080094aa6.shtml

What I was after was actually being able to set a port to up and down on a switch or turn on power on a POE switch using snmp set PDUs .

Is this possible?

Thanks

GD

Gary,

That sounds at least partly doable. For interface up, you could snmpset ifAdminStatus.[ifIndex number of the interface] (1.3.6.1.2.1.2.2.1.7.ifIndex) to 1 (up). As for PoE on the 2800's HWIC, it comes down to if Cisco has included support for pethPsePortAdminEnable or an equivalent OID.

Thanks very much, that was helpful.

I will now have to start trawling the mibs for other interesting things to set-up

GD

Joe Clarke
Hall of Fame Cisco Employee Hall of Fame Cisco Employee
Hall of Fame Cisco Employee

No, the POWER-ETHERNET-MIB is not supported in the 2800 series.  The SNMP/TFTP idea is a workaround for this.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: