cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
165
Views
0
Helpful
0
Replies

Configuring OOB Interface on SG350 with CLI

jtovb2005
Beginner
Beginner

Hello

I am trying to configure a SG350 that is already setup with interfaces and vlans and operating in my network. I am using this guide

https://www.cisco.com/c/en/us/support/docs/smb/switches/cisco-550x-series-stackable-managed-switches/smb5707-configure-ipv4-management-interface-on-an-sg350xg-or-sg550xg.pdf

 

Seems pretty easy. I have assigned an IP of 192.168.10.254 to the oob interface and did no shut command. All looks ok but when I do a show ip int oob command  I see in the IF Status column UP/Down indication. Why? I don't have anything plugged into the oob port yet but when I tried that a few weeks ago same indication. I tried some speed and duplex settings but no change. Should this say UP/UP as soon as I completed configuring it?

Maybe there is another config setting that I need to modify?

Once it works I am assuming I can browse to 192.168.10.254 to get into the gui?

 

Thanks.

 

 

0 Replies 0
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: