I know that CW Common Services 3.3 does not work with pre-defined roles on ACS AAA. So I followed these forums and enabled non-ACS AAA and selected TACACS+. I have a single rule that is matching in my ACS (after looking at the audit trail):
As you may have noticed even though it is matching an access service that allows Priv15. That doesn't seem to be passing through as you can see on top I am only receiving Priv 1. What can I do to properly pass through the access service profile?
CSM can do authentication from a non-Cisco TACACS server and you can register ACS 5.x as such. However, authorization in these cases will have to come from the CSM's internal database.
In short: you can use the ACS for authentication (so the users wouldn't need to remember yet another password) then replicate those users, who you want to access CSM within CSM (it's not important what password you set for them) and set up the access rights you wish to give them from within CSM.
Listen: https://smarturl.it/CCRS9E25 Follow us: twitter.com/ciscochampions
With applications and users everywhere, the networks are now, more than ever, being tasked with delivering consistent protection while providing an exceptional user exper...
Listen: https://smarturl.it/CCRS9E24 Follow us: https://twitter.com/CiscoChampion
Cisco Radio Aware Routing addresses several of the challenges faced when merging IP routing and radio communications in mobile networks, especially those exhibiti...
Listen: https://smarturl.it/CCRS9E23 Follow us: https://twitter.com/CiscoChampion The Wi-Fi 6E Catalyst 9136 access point takes advantage of the 6-GHz band to produce a network that is more reliable and secure, with higher throughput, more ...
When moving from OSPFv2 to OSPFv3, there are many changes in the format of the LSAs Type, but the most known changes are: IP prefix informations are no longer carried in Type-1 LSA and Type-2 LSA, new LSAs Type 8 and 9 are added to carry these prefixes.