cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
982
Views
0
Helpful
2
Replies

Device support for 1240 Access point

sathappan
Level 1
Level 1

Hi,

I have LMS 2.5.1, and I need to add the 1240 access points to the topolgy map. the access points have snmp configured and the devices are discovered, but the devices are shown as unknown devices in the topology map but not with the wireless access point device package.

is there any workaround for this

with thanks

sathappan.s

2 Replies 2

sathappan
Level 1
Level 1

the Problem was solved when I updated to LMS 2.6

thanks

sathappan.s

AFAIK AP1240 is supported by LMS 2.51

I think you should check the device updates on a regular bases to get the most out of LMS.

Cheers,

Michel

Review Cisco Networking for a $25 gift card