cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1846
Views
10
Helpful
6
Replies
Highlighted
Enthusiast

EEM on 2960S LANBASE?

Howdy all.

 

I'm hoping someone can help answer whether EEM is supported on a 2960S switch with LANBASE (not LAN Lite). I'm running 12.2(55)SE9 UNIVERSAL, which, according to Feature Navigator, supports EEM 3.2.

When I try to configure event manager on the CLI, the command is unrecognized.

I have tried this under both the default and lanbase-routing SDMs.

 

Thanks,

Justin

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Hall of Fame Cisco Employee

The 2960 only supports EEM

The 2960 only supports EEM-lite (to drive auto smart ports).  You will not be able to configure your own EEM policies.

View solution in original post

6 REPLIES 6
Highlighted
Hall of Fame Cisco Employee

The 2960 only supports EEM

The 2960 only supports EEM-lite (to drive auto smart ports).  You will not be able to configure your own EEM policies.

View solution in original post

Highlighted
Enthusiast

Good to know. Thanks Joe! I

Good to know. Thanks Joe! I was hoping the EEM guru would chime in. :)

Highlighted
Beginner

I am not able to configure

I am not able to configure EEM script on  WS-C2960-24TC-L running c2960-lanbasek9-mz.150-2.SE7.bin.

Here is the error message. 

IND-HYF-CON-ACC-SW-0(config)#event manager
^
% Invalid input detected at '^' marker.

IND-HYF-CON-ACC-SW-0(config)#e?
eap enable end energywise
epm errdisable exception exit

IND-HYF-CON-ACC-SW-0(config)#e

Not getting option for any command like event manager. 

Highlighted
Hall of Fame Cisco Employee

As already stated in this

As already stated in this thread, EEM is not supported on the 2960 series.   Only EEM-Lite is supported, and this means you cannot configure your own policies.

Highlighted
Cisco Employee

Re: As already stated in this

Hi Joe, how does eem lite differ from eem and where can i get more info about eem lite.

Hall of Fame Cisco Employee

Re: As already stated in this

EEM Lite drives Auto Smartports.  So there are internal hooks to react to CDP/LLDP neighbors, MAC address changes, and  dot1x changes.  There are no external/CLI facing interface for this other than the ASP commands.

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards