Trying to create an EEM script to reset lab gear to a default configuration and/or new version. I want to format the flash then copy over a new IOS and set the boot statement. The script works through the formating of the flash then stops.
!
event manager applet prep4_day0
event none sync yes
action 1.0 syslog msg "Start: 'prep4_day0' EEM applet."
action 1.5 puts "Preparing device to be factory reset - This script will reboot the device."
action 2.10 puts "Starting flash preparation"
action 2.15 cli command "enable"
action 2.20 cli command "format flash:" pattern "confirm"
action 2.25 cli command "y"
action 2.30 wait 30
action 3.0 puts "Starting copy process"
action 3.5 cli command "copy usbflash0:IOS/cat9k_iosxe.16.09.03s.SPA.bin flash:" pattern "cat9k_iosxe.16.09.03s.SPA.bin"
action 3.10 cli command "\n"
action 3.15 wait 300
action 4.0 puts "Starting set boot file"
action 4.5 cli command "boot system switch all flash:cat9k_iosxe.16.09.03s.SPA.bin"
action 4.10 cli command "write"
action 5.0 puts "Erasing startup-config."
action 5.5 cli command "wr er" pattern "confirm"
action 5.10 cli command "y"
action 9.0 puts "Device has been prepped. Rebooting."
action 9.5 syslog msg "Stop: 'prep4_day0' EEM applet."
action 9.10 reload
!
