cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Cisco announces new innovations in SD-WAN, ISRs, SD-WAN Services, and Catalyst 9000 Series switches


76
Views
0
Helpful
1
Replies
Highlighted
Beginner

EEM script to unshut a interface with a delay after being admin downed

I'm new to EEM and how it functions, but I would love to learn. I'm trying to create a simple shutdown/no shutdown EEM script or scripts, but with a delay between the shutdown and no shutdown.

I recently tried using an initial applet to shut the interface, have the admin down syslog trigger another applet, and have that applet run a 3rd applet to no shut the interface... I can already tell that's way more convoluted than it needs to be, but as stated before I'm new to EEM.

Once the second applet runs/triggers for the admin down syslog I receive the error "Embedded Event Manager policy unshut-int not registered with event none Event Detector" 

%HA_EM-6-LOG: trigger : DEBUG(cli_lib) : : IN : switch#event manager run unshut-int
%HA_EM-6-LOG: trigger : DEBUG(cli_lib) : : OUT :
%HA_EM-6-LOG: trigger : DEBUG(cli_lib) : : OUT : Embedded Event Manager policy unshut-int not registered with event none Event Detector

Below are the applets that I have configured.

event manager applet shut-int
event none
action 001 cli command "enable"
action 002 cli command "config t"
action 003 cli command "interface Gi2/13"
action 004 cli command "shut"
action 005 cli command "end"
event manager applet trigger
event syslog pattern "Interface GigabitEthernet2/13, changed state to administratively down"
action 001 cli command "enable"
action 002 cli command "event manager run unshut-int"
action 003 cli command "end"
event manager applet unshut-int
event timer countdown time 5000
action 001 cli command "enable"
action 002 cli command "conf t"
action 003 cli command "interface Gi2/13"
action 004 cli command "no shut"
action 005 cli command "end"

I appreciate any help!

1 REPLY
VIP Advisor

Re: EEM script to unshut a interface with a delay after being admin downed

Hello

You can use tracking instead with a delay 

 

track 10 interface xxx

delay xxx

event track 10

 

 



kind regards
Paul

Please don't forget to rate any posts that have been helpful.
CreatePlease to create content
Ask the Expert- DMVPN on Cisco routers