03-01-2011 07:01 AM
Hello All,
How can i know wich phase of EnergyWise I'm running?
show output:
Switch#sh energywise version
EnergyWise is Enabled
IOS Version: 12.2(52)XO
EnergyWise Specification: (t_nrgyz_v122_52_sg_throttle)1.0.14
Really hard to find clear documentation on this topic.
If I'm running Phase 2 then the "Cisco EnergyWise Configuration Guide" for v2 seriously
needs to be reviewed as lots of listed commands are not available!
Regards,
Thibault.
Solved! Go to Solution.
03-02-2011 05:05 AM
I think that these are just bad examples. If you look at the combatibility matrix
the "Cisco EnergyWise Specification" shows 0.6.n to be Phase 1 and version 1.x is not even listed - but I would assume it is Phase 1. The reason is, that all "Cisco EnergyWise Specifications" which belong to Phase 2 start win 2_x in the above table.
03-02-2011 02:41 AM
according to your output I would say you have Phase 1, version 1.0.14
even there is a document that lists IOS 12.2(52) as Phase 2:
http://www.cisco.com/en/US/docs/switches/lan/energywise/phase2/ios/release/notes/OL19810.html
but as usual, this is just a guideline and certain version of the IOS 12.2(52) train could still be Phase 1
also at the end of this doc you see version 1.0.1
http://www.cisco.com/en/US/docs/switches/lan/energywise/phase1/ios/configuration/guide/cli_comm.html
which is not listed in the first doc I mention
03-02-2011 03:19 AM
Thanks for your answer mermel.
If you look at the Energywise Configuration Guide v1 you can find this output in the doc :
Switch# show energywise version
EnergyWise is Enabled
IOS Version: 12.2(50)SE
EnergyWise Specification: 1.0.1
If you look at the Energywise Configuration Guide v2 you can find this output in the doc :
Switch# show energywise version
EnergyWise is Enabled
IOS Version: 12.2(52)SE
EnergyWise Specification: 0.6.33
Either I'm missing something or I'm getting really confused....
03-02-2011 05:05 AM
I think that these are just bad examples. If you look at the combatibility matrix
the "Cisco EnergyWise Specification" shows 0.6.n to be Phase 1 and version 1.x is not even listed - but I would assume it is Phase 1. The reason is, that all "Cisco EnergyWise Specifications" which belong to Phase 2 start win 2_x in the above table.
03-02-2011 05:16 AM
Nice one. Seems this is what I was looking for.
Thanks.
Thibault.
03-02-2011 06:29 AM
to further add to this discussion, i've just upgraded the switch to the latest IOS release and here is what i have:
Switch#sh energywise version
EnergyWise is Enabled
IOS Version: 12.2(54)SG1
EnergyWise Specification: (rel2_5)1.1.7
It seems the spec keyword "(rel2_5)" is the best way to be sure you're dealing with a Phase 2 EW.
03-02-2011 07:05 AM
thanks for sharing this information!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide