03-01-2011 07:01 AM
Hello All,
How can i know wich phase of EnergyWise I'm running?
show output:
Switch#sh energywise version
EnergyWise is Enabled
IOS Version: 12.2(52)XO
EnergyWise Specification: (t_nrgyz_v122_52_sg_throttle)1.0.14
Really hard to find clear documentation on this topic.
If I'm running Phase 2 then the "Cisco EnergyWise Configuration Guide" for v2 seriously
needs to be reviewed as lots of listed commands are not available!
Regards,
Thibault.
Solved! Go to Solution.
03-02-2011 05:05 AM
I think that these are just bad examples. If you look at the combatibility matrix
the "Cisco EnergyWise Specification" shows 0.6.n to be Phase 1 and version 1.x is not even listed - but I would assume it is Phase 1. The reason is, that all "Cisco EnergyWise Specifications" which belong to Phase 2 start win 2_x in the above table.
03-02-2011 02:41 AM
according to your output I would say you have Phase 1, version 1.0.14
even there is a document that lists IOS 12.2(52) as Phase 2:
http://www.cisco.com/en/US/docs/switches/lan/energywise/phase2/ios/release/notes/OL19810.html
but as usual, this is just a guideline and certain version of the IOS 12.2(52) train could still be Phase 1
also at the end of this doc you see version 1.0.1
http://www.cisco.com/en/US/docs/switches/lan/energywise/phase1/ios/configuration/guide/cli_comm.html
which is not listed in the first doc I mention
03-02-2011 03:19 AM
Thanks for your answer mermel.
If you look at the Energywise Configuration Guide v1 you can find this output in the doc :
Switch# show energywise version
EnergyWise is Enabled
IOS Version: 12.2(50)SE
EnergyWise Specification: 1.0.1
If you look at the Energywise Configuration Guide v2 you can find this output in the doc :
Switch# show energywise version
EnergyWise is Enabled
IOS Version: 12.2(52)SE
EnergyWise Specification: 0.6.33
Either I'm missing something or I'm getting really confused....
03-02-2011 05:05 AM
I think that these are just bad examples. If you look at the combatibility matrix
the "Cisco EnergyWise Specification" shows 0.6.n to be Phase 1 and version 1.x is not even listed - but I would assume it is Phase 1. The reason is, that all "Cisco EnergyWise Specifications" which belong to Phase 2 start win 2_x in the above table.
03-02-2011 05:16 AM
Nice one. Seems this is what I was looking for.
Thanks.
Thibault.
03-02-2011 06:29 AM
to further add to this discussion, i've just upgraded the switch to the latest IOS release and here is what i have:
Switch#sh energywise version
EnergyWise is Enabled
IOS Version: 12.2(54)SG1
EnergyWise Specification: (rel2_5)1.1.7
It seems the spec keyword "(rel2_5)" is the best way to be sure you're dealing with a Phase 2 EW.
03-02-2011 07:05 AM
thanks for sharing this information!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: