Error attempting to distribute image to switch - Prime Infrastructure
I'm trying to deploy an image to a switch (switch was successfully discovered by PI) and I receive the following error:
Here's the version info:
The system configuration for image management is as follows:
So my first obvious question is "Why is it trying to TELNET?". The only reference to TELNET is in the "Config protocol order" section and I removed TELNET from that section allowing it to only use SSH.
This was an ID10T error. Because of the crazy way you have to scroll through windows in PI I didn't realize that there was a whole bunch of other things I needed to click on when I created my SWIM Distribution job (including the checkbox labeled "Use ssh").
The OSPF Type-2 LSA is one of the misunderstanding LSA among all the popular LSAs in OSPF , most people learns that this kind of LSA (Type-2) is generated by DR the Designated Router in a broadcast segment, for example when two or more than two routers ar...
Table of Contents
RADIUS has been the de-facto protocol for Remote Access Authentication for decades. RADIUS/UDP as defined by RFC 2865 has traditionally used MD5 for authentication and integrity. Unfortunately, successful attacks ...
Since 2008, the ASR 1000 platforms have dramatically changed the WAN edge router’s capabilities. With its very own QuantumFlow Processor (QFP) innovation, the data plane was powered to offer advanced scalable services along with high performance. Fast for...
Traditionally Cisco has used several different methods for storing passwords and keys in IOS. The older methods are Type 5 (MD5 hash) & Type7 (Vigenere obfuscation). We enabled Type 7 encryption with the CLI service password-encryption...
AI spoofing detection is a feature in AI Endpoint Analytics released in Cisco DNA Center v220.127.116.11, that identifies endp...