12-23-2016 05:28 PM
we hav just installed an ISR 4431 as internet router.
and has the gi0 as management interface, so want to export FNF thru the management port. SNMP is working ok thru the Mgmt-intf
ping is ok
ping vrf Mgmt-intf 10.1.0.234
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.1.0.234, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/1 ms
but nothing is sent see config extract below
can ping Mgmt-intf 10.1.0.234
flow exporter Prime_exporter
description Exports netflow data to Cisco Prime
destination 10.1.0.234 vrf Mgmt-intf
transport udp 9991
!
!
flow monitor Prime
exporter Prime_exporter
record Netflow
interface GigabitEthernet0/0/0
ip flow monitor Prime input
ip flow monitor Prime output
sh flow exp stat
Flow Exporter Prime_exporter:
Packet send statistics (last cleared 00:22:36 ago):
Successfully sent: 0 (0 bytes) <Nothing sent
Reason not given: 307 (88264 bytes)
Client send statistics:
Client: Flow Monitor Prime
Records added: 2286
- failed to send: 2286
Bytes added: 70866
- failed to send: 70866
Is there any special license required?
12-26-2016 11:45 PM
- Sending Netflow packtets trough the management port (VRF) is unsupported.
M.
12-27-2016 12:43 AM
I think it is now otherwise why would the command " destination 10.1.0.234 vrf Mgmt-intf '
be accepted in the flow exporter configuration??
I was thinking more in the line of a License issue with the ISR 4400
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide