08-23-2022 03:50 AM
Hi,
I have an FMC 1600 Appliance installed with V7.0.1.1
If the appliance loses power I need a lights out Management interface to power the device back on. Via FMC GUI, Console Configuration, there is an option to select Lights Out Management and configure an IP address. However after the IP address has been configured, a reboot is required. After the reboot the LOM IP address has not been saved. When monitoring the reboot from VGA, there is now no option to enter CIMC config mode.
Has anybody managed to configure Lights out Management on an FMC 1600 appliance.
thanks
Ian
08-23-2022 05:42 AM
not sure have followed below document :
08-23-2022 06:03 AM
08-23-2022 08:42 AM
Not sure where went wrong :
08-23-2022 08:56 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide