cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
985
Views
0
Helpful
1
Replies
Highlighted
Participant

Flexible Netflow on WS-C4500X-16

Hi,

I have been trying to setup Flexible Netflow on our WS-C4500X-16. We have configure this as a L3 switch using VRF lite and BGP.

When applying the flow monitor command on the physical interface, I get "% Flow Monitor: Flow Monitor 'NFAmonitor' - Incompatible traffic type: Record has Undetermined, monitor applied with IPv4" error.

Has anyone found a solution to this problem?

Config below.

flow record NFArecorder
 match ipv4 tos
 match ipv4 protocol
 match ipv4 source address
 match ipv4 destination address
 match transport source-port
 match transport destination-port
 match interface input
 match interface output
 collect timestamp sys-uptime first
 collect timestamp sys-uptime last
!
!
flow exporter NFAexporter
 description NMS-NET-PRD1
 destination 10.79.37.3
 source Loopback79
 transport udp 2055
!
!
flow monitor NFAmonitor
 exporter NFAexporter
 record NFArecorder

interface TenGigabitEthernet1/1
 switchport trunk allowed vlan 3436,3438-3441,3443-3445,3451,3517
 switchport mode trunk
 logging event link-status
 logging event trunk-status
 service-policy output Trunk-Egress
 ip dhcp snooping trust

 

ce-k25-1(config)#interface tenGigabitEthernet 1/1
ce-k25-1(config-if)#ip flow monitor NFAmonitor input
% Flow Monitor: Flow Monitor 'NFAmonitor' - Incompatible traffic type: Record has Undetermined, monitor applied with IPv4
ce-k25-1(config-if)#
ce-k25-1#sh ver
Cisco IOS Software, IOS-XE Software, Catalyst 4500 L3 Switch  Software (cat4500e-UNIVERSALK9-M), Version 03.06.00.E RELEASE SOFTWARE (fc3)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2014 by Cisco Systems, Inc.
Compiled Thu 26-Jun-14 12:52 by prod_rel_team

ROM: 15.0(1r)SG10
ce-k25-1 uptime is 6 weeks, 1 day, 6 hours, 16 minutes
System returned to ROM by power-on
System restarted at 05:17:01 AEST Thu Apr 30 2015
System image file is "bootflash:cat4500e-universalk9.SPA.03.06.00.E.152-2.E.bin"
Jawa Revision 2, Winter Revision 0x0.0x41

Last reload reason: power-on

License Information for 'WS-C4500X-16'
    License Level: entservices   Type: Permanent
    Next reboot license Level: entservices

cisco WS-C4500X-16 (MPC8572) processor (revision 9) with 4194304K bytes of physical memory.
Processor board ID JAE18280ATF
MPC8572 CPU at 1.5GHz, Cisco Catalyst 4500X
Last reset from PowerUp
40 Virtual Ethernet interfaces
16 Ten Gigabit Ethernet interfaces
511K bytes of non-volatile configuration memory.

Configuration register is 0x2102

 

Thanks

Regards Peter

 

 

1 REPLY 1
Highlighted
Beginner

Did you ever resolve this? Do you have to get a daughter card on the 4500X to enable flexible netflow?
Content for Community-Ad