- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-15-2021 06:52 PM - edited 06-15-2021 08:33 PM
Hi guys,
Im currently assisting the network team, they want to forward specific log information from some L3, L2 protocol but not all the information, to Graylog. Is there any mechanism to do so, i know there is a discriminator command to filter out log based on level or severity but it is not what i want.
Thanks a lot.
Solved! Go to Solution.
- Labels:
-
Network Management
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-16-2021 12:10 AM
- Check this thread :
https://community.cisco.com/t5/network-management/filter-syslog-on-router/td-p/1673022
M.
-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-16-2021 12:10 AM
- Check this thread :
https://community.cisco.com/t5/network-management/filter-syslog-on-router/td-p/1673022
M.
-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-16-2021 03:36 AM
Not sure what is the requirement here in terms of L3 and L2 ? what device is this ?
i know there is a discriminator command to filter out log based on level or severity but it is not what i want.
most device send based on level 0 to level 7 (then syslog to filter what logs need based on the requirement ?)
can you give example what information you like to send Graylog syslog Server ?
