How do you install RSAC 4.3.2 when upgrading to ciscoworks LMS 3.2.1?

[seencina]

We have ciscoworks LMS 3.2 which we have recently updated to ciscoworks 3.2.1 using the ciscoworks 3.2 Service Pack 1 patch file.  In the "Readme for CiscoWorks LAN Management Solution 3.2 Service Pack 1" document, it says that you have to install the Remote Syslog Collector 4.3.2 separately.  It says the file (setup.exe) is located at disk1/RSAC.  However, ciscoworks 3.2 Service Pack 1 only appears to be a patch file and when we ran the patch file on our Remote Syslog Collector server, the version remained at 4.3.0.  When I looked at the server where RME is installed (version 4.3.2), it says that Syslog Analyzer is 4.3.2 and Syslog Collector is version 4.3.0.  The patch file doesn't look like it has the installation files for RSAC 4.3.2 and there doesn't seem to be a directory that was created on the RME server to install the updated RSAC from, so how do you upgrade from RSAC 4.3.0 to RSAC 4.3.2?

[seencina]

I opened up a TAC case, worked with TAC, and was able to update RSAC to version 4.3.2.  The procedure is:

1. Download the ciscoworks LMS 3.2.1 patch file to the remote syslog server.

2. Create a temporary directory on the remote syslog server (ex. c:\test)

3. Go into the directory with the extracted LMS 3.2.1 patch file and type the command:

Ciscoworks_LMS_3.2.1.exe /extract_all:c:\test

4.  Go into the c:\test directory and find the RSAC folder.  In the RSAC folder is a setup file.  Run setup and install RSAC 4.3.2 over RSAC 4.3.0 (if you uninstall RSAC 4.3.0, you will get a message saying that RSAC 4.3.0 must be installed before installing RSAC 4.3.2)

5. Check the installation by going to Common Services->Software Center->Software Update on the remote syslog server.  The version should be RSAC 4.3.2.

[Robert Pavone · Accepted solution]

The steps above worked for Shon, thus is the correct answer