cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1066
Views
0
Helpful
2
Replies

How to config RME Software Distribution to NOT use telnet--use SSH only to connect to Switch

Gongyuan Yao
Level 1
Level 1

We have LMS 3.2 installed. I am trying to use RME Software Distribution feature to upgrade switches’ IOS.  When I went to RME->Software Mgmt->Software Distribution->Distribute by Devices,  select one device, then software was doing verification, fail returned. The reason was:

“SWIM5001: Cannot connect to the device 192.168.6.53 using TELNET.”

Telnet has been disabled in all of our switches, we only allow SSHv2. Where can I config the CiscoWorks to not use telnet, and use SSH. I think it should be in Common Service, but just cannot find it.

Any help would be great.

Thanks.

1 Accepted Solution

Accepted Solutions

yjdabear
VIP Alumni
VIP Alumni

The SWIM transport settings are under RME - Admin - Software Mgmt - View/Edit Preferences, i.e. http://hostname:1741/rme/SwimAdminAction.do

View solution in original post

2 Replies 2

yjdabear
VIP Alumni
VIP Alumni

The SWIM transport settings are under RME - Admin - Software Mgmt - View/Edit Preferences, i.e. http://hostname:1741/rme/SwimAdminAction.do

Thanks a lot. I missed the check box there. It is working

correctly now.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: