Solved: How to remove switch ports for interface utilization in Prime - Cisco Community

355

Views

5

Helpful

1

Replies

How i can remove switch ports from up down status alert as well as from interface utilization TX and RX in Cisco Prime. I want only the WAN links to show up with this detail.

1 Accepted Solution

Accepted Solutions

If you do not like to send alerts for the normal interface, you can configure on switchport

no logging event link-status

no snmp trap link-status

On prime you can also supress :

Monitor / Monitoring Tools / Monitoring Policies

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

View solution in original post

1 Reply 1

If you do not like to send alerts for the normal interface, you can configure on switchport

no logging event link-status

no snmp trap link-status

On prime you can also supress :

Monitor / Monitoring Tools / Monitoring Policies

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

Recognize Your Peers

Spotlight Award Nomination