01-02-2005 02:33 PM
Hi,
I just configured a network analysis module. The system ask me reboot to take effect. But after reboot, I lost the ip address setting for the internal interface, So how to save the config in NAM?
Any good cisco DOC link?
Regards
01-02-2005 06:51 PM
Is this the NM-NAM module?. If so, do you also see an error message like "Chip reports voltage low"?. If so, then this will cause the NM-NAM to loose it's ip config after a re-boot. There is already a field notice on this: http://www.cisco.com/en/US/products/sw/netmgtsw/ps2244/products_field_notice09186a0080357efc.shtml
You need to apply the latest NM-NAM patch from CCO to fix this problem. Details are the above URL.
01-02-2005 07:06 PM
Thank you very much!
Yes, I saw those error message. I will load the latest patch.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide