cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
467
Views
0
Helpful
1
Replies

how to unregister CW applications from ACS?

agipkcolon
Level 1
Level 1

Guys,

I was trying to unregister CW Applications (LMS2.6) from one of our ACS appliances (4.1) using perl.exe acsregcli.pl -unregister all

but for all applications it says FAILED.

Is there a reason why it is failed?

1 Accepted Solution

Accepted Solutions

Joe Clarke
Cisco Employee
Cisco Employee

It could be your ACS admin username as specified in LMS does not have enough access to unregister the applications in ACS. This ACS admin must have all access to all ACS components, and must NOT be the appliance administrator (if this is an appliance).

View solution in original post

1 Reply 1

Joe Clarke
Cisco Employee
Cisco Employee

It could be your ACS admin username as specified in LMS does not have enough access to unregister the applications in ACS. This ACS admin must have all access to all ACS components, and must NOT be the appliance administrator (if this is an appliance).

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco