I am trying to configure ip accounting on a Cisco 1801, it does show the command as in within show, but I am unable to configure it.
Does anybody has an idea why?
router#show ip accounting ? access-violations show access violations in accounting database checkpoint The checkpointed IP accounting database output-packets show output packets in accounting database | Output modifiers <cr>
router#conf t Enter configuration commands, one per line. End with CNTL/Z. router(config)#interface fastEthernet 1 router(config-if)#ip ? Interface IP configuration subcommands: address Set the IP address of an interface ddns Configure dynamic DNS dhcp Configure DHCP parameters for this interface igmp IGMP interface commands rsvp RSVP Interface Commands vrf VPN Routing/Forwarding parameters on the interface