07-29-2015 02:01 AM
Hi,
I am trying to configure ip accounting on a Cisco 1801, it does show the command as in within show, but I am unable to configure it.
Does anybody has an idea why?
Command line:
router#show ip accounting ?
access-violations show access violations in accounting database
checkpoint The checkpointed IP accounting database
output-packets show output packets in accounting database
| Output modifiers
<cr>
router#conf t
Enter configuration commands, one per line. End with CNTL/Z.
router(config)#interface fastEthernet 1
router(config-if)#ip ?
Interface IP configuration subcommands:
address Set the IP address of an interface
ddns Configure dynamic DNS
dhcp Configure DHCP parameters for this interface
igmp IGMP interface commands
rsvp RSVP Interface Commands
vrf VPN Routing/Forwarding parameters on the interface
Solved! Go to Solution.
07-30-2015 08:24 AM
Hi the interface has to be layer 3 have you got an ip address on it 1st before trying to implement accounting ?
07-30-2015 08:24 AM
Hi the interface has to be layer 3 have you got an ip address on it 1st before trying to implement accounting ?
07-31-2015 12:53 AM
I'm able to shoot myself right now - thank you for the answer!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide