cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
378
Views
0
Helpful
2
Replies

ip accounting cisco 1801

uhuFAT32x
Beginner
Beginner

Hi,

I am trying to configure ip accounting on a Cisco 1801, it does show the command as in within show, but I am unable to configure it.

Does anybody has an idea why?

 

Command line:

router#show ip accounting ?
  access-violations  show access violations in accounting database
  checkpoint         The checkpointed IP accounting database
  output-packets     show output packets in accounting database
  |                  Output modifiers
  <cr>

router#conf t             
Enter configuration commands, one per line.  End with CNTL/Z.
router(config)#interface fastEthernet 1
router(config-if)#ip ?
Interface IP configuration subcommands:
  address  Set the IP address of an interface
  ddns     Configure dynamic DNS
  dhcp     Configure DHCP parameters for this interface
  igmp     IGMP interface commands
  rsvp     RSVP Interface Commands
  vrf      VPN Routing/Forwarding parameters on the interface

1 Accepted Solution

Accepted Solutions

Mark Malone
Mentor
Mentor

Hi the interface has to be layer 3 have you got an ip address on it 1st before trying to implement accounting ?

View solution in original post

2 Replies 2

Mark Malone
Mentor
Mentor

Hi the interface has to be layer 3 have you got an ip address on it 1st before trying to implement accounting ?

I'm able to shoot myself right now - thank you for the answer!

 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: