Mar 5 10:27:06.976: %RTT-3-IPSLATHRESHOLD: IP SLAs(3): Threshold below for rtt
Mar 5 10:27:06.980: %RTT-3-IPSLATHRESHOLD: IP SLAs(3): Threshold below for rtt
And therefore, causing EEM to act twice ..which is a memory/cpu waste.
Mar 5 10:26:47.516: %SYS-5-CONFIG_I: Configured from console by vty1
Mar 5 10:26:47.620: %SYS-5-CONFIG_I: Configured from console by vty2
Using average or immediate works just fine.
One more thing ..i'm not sure if I understood 'average' , does it mean that if you have it configured for 5 attempts , you for example get a failure today, and the other day another 4 failures then it will trigger?
Here is my IOS:
Cisco IOS Software, 2800 Software (C2800NM-ADVENTERPRISEK9-M), Version 15.0(1)M
PRTG system in place running other sensors on the same host, which are working. Ive added syslog receiver sensor and receiving PRTG data from switch that increases drops, errors and warning stats that disappear after a few minutes. Within mess...
Hi, here is an example how to configure IP-NAT, GRE, IPSEC. I've seen plenty of questions and this might be a good solution! (Mostly the use of commands that might remind u) IP NAT======================================================================...
Hi everyone.I have a problem in my Network.So i have 3 routers and a firewall in my topology. I have configured OSPF and all routers works expect R3 (see in the image below)When I watch my neignbor in R3 it says :192.168.7.7 1 INIT/DROTHER 00:00:37 10.0.2...
Host Onboarding is the term used when connecting an endpoint (hosts , IOT , Other devices) to the fabric , and can be accomplished in a couple of ways.One option is the "static" approach as oppose to the dynamic and secure approach using&nbs...