cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
248
Views
2
Helpful
2
Replies

Layer 2 Network - Access port and ping device - do i misunderstand?

rumak18
Level 1
Level 1

Hello,

i am not sure if i understand accesssing Layer-2 devices from devices correctly. 

I have a Cisco Switch (i guess it does not matter which one) . See attached file.

There is an INT GI0/1 where i have a computer connected . This interface is configured as an access port with vlan 39.

There is also an INT Gi0/2 where i have another computer connected. This Interface is configured as a access port with wlan 100.

I also have a router (internet access) also configured via access port (VLAN 100) to the switch.

Now i'm trying to ping the device in vlan39 from the switch and also from the computer in vlan 100. But both pings fail. 

I would at least have expected the switch to ping the computer in vlan 39 as it is directly conned. Am i misunderstanding here something? 

Just for clarity, there is no other ip interface on the switch. 

1 Accepted Solution

Accepted Solutions

Joseph W. Doherty
Hall of Fame
Hall of Fame