12-30-2009 10:46 PM
I am using LMS 3.2 as syslog server.
I have set purge settings. Ther is enaughe free space on a disk. But when the nmber of syslog messeges increases up to 10 000. it stops to collect them.
So all messages will be lost if it is fool.
How can I change 10 000 limit for about 100 000 ???
Solved! Go to Solution.
01-11-2010 08:13 AM
Hi,
Are you running the report job as an IMMEDIATE job? I seem to remember that this will limit the output to 10,000 syslog entries.
If you run the job as SCHEDULED, run it ONCE with a start time of say 5 minutes from the current time, I think it should show all syslog entries.
Give it a go anyway.
Pete
12-31-2009 06:46 AM
If you're referring to the "SLCA0131: There are more than 10000 records generated for this date range.
Only 10000 records are being displayed, starting with the records generated on the end date." message when generating a syslog report, I don't think the answer has changed since this thread below:
http://supportforums.cisco.com/message/638820#638820Re: Cisco works cant display more then 10k of syslog error
Your syslogs are not being lost though. You can still view them in the raw syslog_info file(s) on the CLI.
01-10-2010 10:11 PM
01-11-2010 08:13 AM
Hi,
Are you running the report job as an IMMEDIATE job? I seem to remember that this will limit the output to 10,000 syslog entries.
If you run the job as SCHEDULED, run it ONCE with a start time of say 5 minutes from the current time, I think it should show all syslog entries.
Give it a go anyway.
Pete
09-07-2010 02:40 AM
That works indeed.
Regards Marco
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: