cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
601
Views
0
Helpful
1
Replies

LMS 2.6 Devices not in ACS Report

nickmaiolo
Level 1
Level 1

Sometimes, if i add a device to LMS 2.6, it doesnt appear in the DCR straight away, but does show in the "devices not configured in ACS" report. However the devices are in ACS, and after i stop/start dmgtd, the devices appear in the DCR.

Obviously i dont want to be stopping/starting the daemons everytime i add a device.

Any idea what is causing this or how LMS gets the information from ACS (Can this information be refreshed without restarting all daemons etc)?

For info, we are running LMS 2.6 on solaris, connecting to ACS 4.0.1.

Cheers

Nick

1 Reply 1

Joe Clarke
Cisco Employee
Cisco Employee

There used to be a bug with this, but now you should be able to see new devices in DCR after logging out of LMS then back in (at the most).

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco