cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Community Helping Community

332
Views
0
Helpful
3
Replies
Beginner

LMS 3.1

Is it possible to restart some of LMS applications, with no restarting server?

For example restart RME. But do not restart the all server.

Everyone's tags (2)
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Cisco Employee

Re: LMS 3.1

This is not easily done since RME contains many processes.  However, if there is a certain feature of RME, that may be restartable.  For example, if you want to restart the config archive process, do the following:

pdterm ConfigMgmtServer

pdexec ConfigMgmtServer

View solution in original post

3 REPLIES 3
Hall of Fame Cisco Employee

Re: LMS 3.1

This is not easily done since RME contains many processes.  However, if there is a certain feature of RME, that may be restartable.  For example, if you want to restart the config archive process, do the following:

pdterm ConfigMgmtServer

pdexec ConfigMgmtServer

View solution in original post

Beginner

Re: LMS 3.1

ok) phank you!

but were i can deploy this comands? I don't see any CLI in LMS?

may it is on windows 2008 server cmd? or not???

Hall of Fame Cisco Employee

Re: LMS 3.1

You need to run these commands from the server's command line.  You can also perform the same stop/start operation via the web by going to Common Services > Server > Admin > Processes.

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards