I'm having problems with the Discovery of a Switch 4507R+E.
I'm using the LMS 4.0 version and when I do the discovery, it finds it, however, when I want to see it on the Topology Map. It shows a "?" in the device but I can see the rest of the devices connected to it.
Ive checked the Supported Devices Table and it does shows under Supported Devices.
At the same time, it is using a Supervisor Engine 7E and it is not found by the LMS. Again, I searched it on the supported table and i didnt find it. However, in the 4.0.1 version of LMS, it does appear. Therefore, my question is, this sup is not supported in the 4.0??
Currently when changing the Authentication Template under the Onboarding section, there is no choice but to remove SGTs, VNs and IP Pools which clearly disrupt existing services.
Hitless Authentication was introduced in...
Hi, I want to redistribute OMP routes to BGP, i have the doubt if all of the OMP prefixes located in the local vEdge will be redistributed to BGP or just the connected+static networks located in the vEdge. Also how can i restrict some OMP prefix...
Let's say we have two routers configured as RP candidates for auto-RP: R1 - "advertising" its loopback0 interface IP address 126.96.36.199 as the RP for these groups:188.8.131.52/32184.108.40.206/32220.127.116.11/2418.104.22.168/16 R2 - "advertising" its loopback0 int...
hi,i just performed an IOS upgrade and got a report that admin can't create L2 VLANs.i noticed the 'vtp primary force' and 'vtp primary mst' was applied to one of the core switch and perhaps got lost after the upgrade.how to keep the VTP primary persisten...